I have a 2004 ES330 following a hestitation problem. It is fine from a full end but bearing in mind I go approximately turns on onto highway ramps, as soon as I hurt the accellarator (sp?) it hesitates for 2 seconds past reving up. I ve taken it to a mechanic and he says it is normal. I have an 2003 Avalon similar to the thesame engine and it jumps off the start and has no hesitation. Mechanic s Assistant: Will the headlights slope on? Is the battery thoroughly charged? With or without headlights on. Relatively new battery. Mechanic s Assistant: What is the model of your 04 Lexus? ES330 Mechanic s Assistant: Are you fixing your vehicle yourself? What have you tried suitably far? I ve cleaned the MAF sensor. Checked for contacts in the intake. similar to I put my Turbo OBDII app on, all seems fine except that the TPS stays constant roughly speaking 30%. This is a drive-by-wire model as a result it has not throttle cable or normal TPS. I allow the TPS is integrated subsequent to the throttle controller/motor. Mechanic s Assistant: everything else you want the mechanic to know since I link up you? No, I guess that is it.
I'm 1500 too high.. or more. It's boggling to me how this hardship has morphed into various idle problems and has everyone perplexed.. or suitably it seems. I've been dealing in the manner of this previously July.. makes me appreciate my 240z 10 times more.My dad owns an sc400 and its been truly good to him.. I'm having a difficult era not physical cutting behind this purchase. I realize atmosphere afterward its a good car though. Motor sounds attractive and is super mild once paperwork right.
This could be a large vacuum leak ,with the MAF partnered it is lonely measuring the let breathe that is getting next the MAF, hence if the intake manifold is sucking in ventilate the ventilate to fuel ratio will be unconditionally out and cause the engine to stall. If MAF is disconnected the engine goes into a limp measurement and lets the engine run. afterward carb cleaner vaporizer spray can in the place of the hissing bearing in mind the engine supervision and taking into account you hear the engine stall or rev innovative there is the leak ,could be a bad vacuum hose bad gasket upon the manifold.